Long Shaft Vs Short Shaft Outboard Motors.This is a comparison between long shaft and short shaft Outboard motors… The decision between a short shaft and a long shaft outboard motor should be based on your specific boating needs and the characteristics of your vessel. Short shaft outboards excel in shallow waters, smaller boats, and inflatable vessels, while long shaft outboards are better suited for deep waters, sailboats, high transom boats, and trolling.
Long Shaft Outboard Motor All You Need to Know Before Purchase
Long Shaft Vs Short Shaft Outboard Motors YouTube
Honda 2.3hp Outboard Motor (Short Shaft) in operation YouTube
How To Measure Outboard Motor Shaft Length [Long v Short]
Outboard 5Hp Short Shaft 4 Stroke Smart Marine
Short Shaft Outboard eBay
Outboard Shaft Length Chart
Long Shaft Vs Short Shaft Outboard What Are The Differences Hot Sex Picture
Outboard 9.8Hp Long Shaft 2 Stroke Smart Marine
Long Shaft Vs. Short Shaft Outboard (What Are The Differences?) Project Boating
CONVERTING A LONG SHAFT OUTBOARD TO A SHORT SHAFT OUTBOARD (PART 2) YouTube
Mercury Conversion Kit Long Shaft to Short Shaft 2001 2 Stroke eBay
1518hp short shaft outboard Bloodydecks
Outboard Issues, Long Shaft Vs. Short Shaft The Hull Truth Boating and Fishing Forum
Testing 15″ short (S) shaft outboard motor performance with Wavewalk kayaks and boats Wavewalk
The Beginner’s Guide to Boat Transom Heights My Westshore
FiberGlassics® Short shaft vs long shaft on Dorsett FiberGlassics® Forums
What happens if your outboard shaft is too long? Quora
Buying Guide Riverside Outboards 6032105095
LONG SHAFT OUTBOARD TO SHORT SHAFT CONVERSION (have mercy) YouTube
Depending on the architecture of your boat, you will need more or less shaft length so that the propeller is submerged to the right depth. If the propeller is too low, it may bottom out. If the boat’s propeller is too high, it will suck in air and lose performance. The choice between a short or long shaft boat motor is therefore essential.. May 30, 2002. #2. Re: long vs short shaft outboards. Shaft length is measured from the part of the clamp that rests on the top of the transom to the cavitation plate.I believe the cavitation plate should be at least where you indicate.I would think you would run it as deep as is practical.You dont want the powerhead so low waves wash over it.


